🎽 Ford Mondeo Door Lock Problem

Remove the plastic gromit locate above the latch mechanism. Loosen the torx screw until the the door handle can be removed. The mechanism should then be free to remove (assuming the 3 torx bolts securing it have already been removed as stated earlier) 2003 Mondeo Graphite 115 TDCI in magnum grey 67K. This week my good friend Emanuel brough his car a Ford Mondeo Parking Sensors Not Working, with a few very simple checks we managed to find the problem and f Ford Mondeo (Mk4; 2007-2010) fuses. In this article, we consider the third-generation Ford Mondeo (Mk4) before a facelift, produced from 2007 to 2010. Here you will find fuse box diagrams of Ford Mondeo 2007, 2008, 2009 and 2010, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse Here are the most common symptoms when the door jamb switch has failed, or the door ajar warning stays on. Dome light on – If your Mondeo thinks that the door is ajar, it’ll leave the dome light on. This can create some visibility issues at night. Most vehicles have some sort of switch that can deactivate the dome light. How do you reset the central locking on a Ford Mondeo W reg? The keyfob remotes don't seem to work, when I press any of the three buttons (lock all doors/open all doors/open boot) none work. The red LED light is permanently on, on the dashboard. The alarm doesn't come on. The rear doors have child locks and I cant get them open. Use lots of this stuff and it will run out of the bottom of the door. Work lock many times and do it again, lots of WD being used. ( wish i had shares ho ho) It is often the door closed switch which is in the lower part of the door lock. After doing this a few times leave for a week and spray with Silicone grease or liquid grease. In our case, with the Ford Mondeo, the following article explains that the door control is achieved on MS-CAN with a rate of 125kbit/s. Since the OBD connector on Mondeo MK4 is compatible with the AutoPi (read more about AutoPi CAN-BUS User Guide), it is possible to decode the messages on the AutoPi and replay them. I have the same problem on my 05 Mondeo Zetec passenger door, have to tug really hard to get it to open, internal catch and central locking is fine. I have just removed the door card and examined the mechanism, I think that the pushrod going down to the release mechanism doesn't quite go far enough, a slight extra push by hand on the inside Ford call it a "retainer - lock C", the part number is 1074569 and it cost £2.99. With the new "retainer lock" fitted, my outside door handle works well; with the rod in a position similar to the one in gardun's picture above, ie sticking out of the top of the "retainer - lock" by 2 to 5 mm. 203. Name: ferret. Ford Model: focus zetec 2007. Ford Year: 2007. UK/Ireland Location: Devon. Posted August 3, 2015. i'm sure that key slot behind the catch should be either horizontal (child lock on) or verticle ..try and turn that so its vertical then use the outside handle to test ( if the child locks stuck it wont open from inside) Quote. Still, worth checking if electric windows work, because if there is a problem with the loom then the whole door can "die" electrically. Does mk3 Mondeo have door modules, or is it centrally controlled? The Mondeo's double locking key facility means you can remotely close all the electric windows, as well as deadlocking all the doors. So if an intruder gains entry by breaking the windows, they will be unable to unlock the doors from inside. You can activate double locking simply by pressing the 'lock' button on the key fob twice. .

ford mondeo door lock problem